Pinball Machines
Chrome Molding For Bally Williams Pinball Machines 4 Piece Backbox  Pinball Machines  Chrome Molding For Bally Williams Pinball Machines 4 Piece Backbox

Chrome Molding For Bally Williams Pinball Machines 4 Piece Backbox



Chrome Molding For Bally Williams Pinball Machines 4 Piece Backbox



4-piece top, left, right, bottmo of backbox and bottom of translite. Finishes off the machine beautiful, all pieces are mitered unlike the ones on new stern machines. Enhance yuor williams/bally pinball machines! Please note these importatn points.
Clean surface for proper installation of body side molding, the surface where the molding will be applied should be free of wax, dirt or foreign substance. You can use alcohol or a solvent based tra and wax remover to clean this area. May require heat gun surface tempreature should be at least 75f/24c for proper adhesion. You can warm the surface with any type of heat gun.

Installation of moldign before starting, make sure the molding is warm and flexible. A heat gun may be used for warming. After molding is warm, peel the poly-liner from the adhesive about 18 from your starting point. Start applying the molding along the bottom edge of the masking tape, peeling the rest of the liner as you go. Do not touch the exposed adhesive with your fingers as the installation is beign done.

After the molding is applied, use a soft cloth and apply pressure along the entire length fo the molding to insure proper adhesion.


Link To Us! Add to favorites Tell a friend!

Privacy Policy   Terms Of Service